Page 10
autocut 5-32cts user manual edItIon II 2015-01-16
Page 11
autocut 5-32cts user manual edItIon II 2015-01-16
5.4 Tool change
HYDROSCAND MACHINE AB
Kungsvägen 22
Phone: +46 (0)225 - 573 30
S-783 35 Säter
Fax:
+46 (0)225 - 501 08
Sweden
Web:
www.hydroscand-machine.se
Edition 7-00
MANUAL-E
Page 9
First tool (inlet) is assembled between
the two aluminium blocks.
Choose the tool with 3-4mm bigger
hole than the hose OD size to avoid
problems during feeding of the hose.
The cutting side tools is assembled in
the same way as the first one.
Remember to have the same size on all
3 sets of the tooling.
This is the tools when correct
assembled and ready to use.
The tools has a size marking on the top.
It's not possible to assemble the tools
incorrectly.
The hose end shall always extend at
least 10mm outside the last tool before
start.
6.4 Hose guide toolings
first tool (inlet) is assembled between
the two aluminium blocks.
choose the tool with 3-4mm bigger
hole than the hose od size to avoid
problems during feeding of the hose.
the cutting side tools is assembled in
the same way as the first one.
remember to have the same size on all
3 sets of the tooling.
this is the tools when correct
assembled and ready to use.
the tools has a sizemarking on the top.
It’s not possible to assemble the tools
incorrectly.
the hose end shall always extend at
least 10mm outside the last tool before
start.