HydroMatik LPS, Operating Manual

Page: 21 / 70

Page 21
7. Mechanical assembly
Caution: The device may only be assembled by qualified staff.
HygroMatik accept no liability for damages resulting from incor-
rect assembly.
Observe all safety instructions and warnings found on the
device. The device must be de-energised during assembly.
Mounting or insertion of additional devices is only permitted with
the written consent of the manufacturer. Otherwise the guaran-
tee and warranty will become void.
7.1 Overview of the humidification chamber
1: Vortex module wall with spray system
2: Droplet separators
3: Upper guide rails for droplet separators
4: Lower guide rails for droplet separators
5: Collection tray
6: Drain with trap
7. Guide rails for vortex module wall
8. Humidification section, >/= 0.9 m
9. Two supplied bushings for the duct (for partial-load / full-load
switching) for connecting high-pressure hoses * Only one bush-
ing is needed for the standard model.
10. Distribution pipe
Note: In front of the vortex module wall and from the droplet
separators a minimum distance of 0.3 m to other installed com-
ponents must be maintained (see above schematic). In case of
an upstream installation of a fan in front of the vortex module
wall, the minimum distance shall be 1 m or appropriate action
has to be taken in order to ensure a laminar flow of the vortex
module wall. Temperatures higher than 60°C may destroy the
vortex modules.