Page 40
9.3
Drainage
At the bottom of the housing, a DN12 spout is sticking out. This
is a drain and is used to:
•
empty and relieve the pressure lines to the vortex wall
after removal of the module enable signal
•
drain the flush water after flushing
Water drainage
»
A DN12 water hose (position 4 on the graph above) is
attached to the DN12spout on the bottom and made
fast with a clamp.
»
The tube is then siphoned off and installed on the slope
to the drain (8).
9.3.1
Water drain for the humidification chamber
Note:
The water drain in the collection tray must be at the lowest
point in the humidification chamber.
It is recommendable to have the water drain positioned behind
the droplet separators with respect to the direction of air flow.
Only in this way can the waste water drain completely.
Summary of Contents for LPS
