HydroMassage Owner’s Manual, Revision 10-25-15
JTL Enterprises, Inc 1-727-536-5566 • www.HydroMassage.com
Page 21 of 33
7) Turn on Touchscreen by pressing blue “Power” button on Touchscreen Monitor
(Models 340L, 350L, 500, and 700 Only)
•
**IMPORTANT: Do this first before plugging 220V electrical cord into the wall outlet. The
HydroMassage software will boot up automatically on the screen. Wait until you see an “Establishing
Communication” window on the Touchscreen before plugging in 220V outlet.
8) Plug the 220V power cord into the 220V wall outlet
o
Important** DO NOT plug in the 220V power cord for the Lounge until the Touchscreen is
powered-up, and the “Establishing Communication” box pops-up on the Touchscreen.
9) Software initialization. You should see a series of tests being completed on the Touchscreen. This
will take approx. 1-2 minutes
•
If Initialization process does not begin, unplug the power cord, and call HydroMassage technical
support at 727-536-5566.
•
During and after the initialization phase on the Touchscreen, you will see a “ Water Temp Cold Error”,
This is normal until the Lounge has run to warm the water
10) After the initialization window disappears from the Touchscreen, add the remaining 15 gallons of
water
•
Once all water is added, Lounge sure to screw in the cap at the end of the fill spout
Wall Outlet with
NEMA L6-30R
Locking Receptacle
X
Y
G
Battery Backup
Power Button
Establishing
Communication
Window
Power Button
