HydraMaster CTS 403 Flex, Owner'S Manual

Page: 24 / 140

2-3: Operating Instructions
7. Block off the vacuum inlet to the waste tank and allow TM to warm up for 2-3 minutes.
8. Attach and route drain hose for Auto Pump Out if equipped/necessary. Turn on APO.
The PUMP OUT system will not engage until the water level rises inside the recovery
tank.
9. Un-cap vacuum and attach vacuum hose to unit and cleaning tool.
10. Begin cleaning.
The machine will automatically shut down when it reaches its full capacity due to
the float switch located inside the recovery tank. When this occurs, turn the Solution
Control switch to “OFF” and empty the recovery tank. Then, turn the unit back on and
continue to clean.
LTR REVISION DESCRIPTION CODE DATE BY CHKD APPVD
D
C
B
A
A
B
C
D
1 2 3 4 5 6 7 8
8 7 6 5 4 3 2 1
E
F
E
F
MACHINE
FINISH
125
SCALE: 1:4 SHEET 1 OF 1
PROPRIETARY INFORMATION
11015 47th Avenue West,
Mukilteo, Washington 98275
D
SIZE
BREAK ALL SHARP EDGES 0.005-.015
UNLESS OTHERWISE NOTED
DIMENSIONS ARE IN INCHES
PART NUMBER
WEIGHT: APPLICATION
NEXT ASSY USED ON
610-018-749
REV
ASSEMBLY, DASH - CTS 403 FLEX
PRJ000245
CTS 403 FLEX 610-050-749
- - - - - -
- - - - - -
- - -
- - -
- - - - - -
M.B.B.
M.B.B.
L.O.L. DRAWN
CHECKED
APPVD
12/18/2019
12/19/2019
12/19/2019
TOLERANCES
.X= .1
.XX= .03
.XXX= .010
ANGULAR = 2°
CODE: 21.09
CARPET/UPH.
Selection
Figure 2-2. Select “CARPET/UPH.” on Solution Control Switch