Operating the ContaminationSensor (display is optional)
OLFCM 15/30/45/60
en(us)
41 / 84
BeWa OLFCM 15-60 3595923a en-us 2018-06-28 .docx
2018-06-28
Operating the ContaminationSensor (display is optional)
If the sensor is switched on or supplied with power, the display shows
HYDAC CS1000 in moving letters, then the firmware version is displayed for
2 seconds.
This is followed by a countdown:
WAIT99
…
WAIT0
.
The duration of the countdown corresponds to the set measurement time
MTIME. This means that the countdown runs from 99 ... 0 within the set
measurement time (factory setting = 60 sec).
Item
LED
Designation
A
Status
Status display
B
Display
6-figure display with 17 segments each
C
Measured
variable
Display of respective measured variable,
e.g:
ISO / SAE / NAS
D
Service variable
Display of respective service variable,
e.g.:
Flow / Out / Drive / Temp
E
Switch point 1
Indicates the status of the switching output. When
the LED is lit, the switching output is activated, i.e.
the switch is closed.
F
Switch point 2
Reserved
