Hyd-Mech PH 211, Use And Maintenance Manual

Page: 69 / 98

7--11 62
"
Position the square on the work surface close to the front head.
"
Repeat the squaring operations as for the rear head.
Orthogonality of the blade
The procedure for correcting and adjusting the blade to 0 ˚ , 45 ˚ right and 45 ˚ and
60 ˚ left, to make cuts at right angles to the fixed vice jaw is described below.
To make orthogonal adjustments at 0 ˚ , use a workshop goniometer or a simple
90 ˚ square. Operation sequence:
"
lower the head;
"
position the goniometer or square, resting it on the fixed vice jaw adjacent to
the blade;