Hyd-Mech PH 211, Use And Maintenance Manual

Page: 38 / 98

5--8 32
Use and maintenance manual PH211
"
Relock the turntable lock/release lever.
"
Make the cut in the required operating mode, following the preliminary
safety instructions set out in this chapter.
Angled cuts 60
˚
to the left
"
Slacken the turntable lock/release lever;
"
pull the eccentric pin knob towards you (0 ˚ reference stop) and rotate slightly
to raise it;
"
swing the head from left to right until it is positioned at the required angle, as
indicated by the graduated scale on the turntable;
"
relock the turntable lock/release lever;
"
make the cut in the required operating mode, following the preliminary safety
instructions set out in this chapter.