Hyd-Mech PH 211, Use And Maintenance Manual

Page: 29 / 98

4--7 23 Machine installation
"
Insert the plug in the socket, ensuring that the mains voltage is the same as
that for which the machine has been setup.
VOLT ? VOLT ?
"
Power up machine by rotating the main switch located on the right side of the
control panel (The STAND BY LED lights up).
Check that the motor is rotating in the correct direction. For this check the
following operations must be carried out:
"
set the blade tension to 70 BAR;
"
make sure the cover is properly closed: at the back of the cutting head there is
a bayonet limiter for correct cover closure;
"
make sure that the machine is not in an emergency condition (red mush-
room---head pushbutton released);
"
select a cutting speed using the polarity change switch;