Hy-Security SwingRiser 14, Installation And Reference Manual

Page: 34 / 86

Installation and Maintenance Manual
24
b. Press the Program Menu button and watch the LCD scroll the system data, or press the
Program Menu key a 2
nd
time to skip the scroll.
c. The LCD display scroll will stop at the menu item for the auto close timer setting [Ct __].
This is the first item in the User Menu.
d. To access the more detailed Installer Menu, the system must first be in the User Menu,
and then simultaneously press the Reset button and the Open button (early Software
versions require the Reset button be pushed first and held while the Open button is
pressed). The LCD will change to display the UL usage class menu item [uC __]. This is
the first item in the Installer Menu.
4. Pressing the Program Menu button when the User or Installer Menu is not blinking will return the
system to the Run Mode.
Installation Configuration for Smart Touch Controller
Basic Configuration and Setting of the Usage Class
1. The hydraulic hoses must be connected to the quick couplers by matching the color coded ends
to configure the correct directional control of the gate. If the hoses are connected incorrectly, the
gate will run backwards (close when open button is activated) and this may trigger an error [Err 1]
on the LCD display. (The Reset button must be pushed if this happens).
2. Turn on the power switch and observe that the LCD will first show the software version, and then
stop at a steady display within two seconds. If the display reads [uC 0] go to step 3. If the
operator has previously been configured, the Installer Menu must be accessed in order to reach
the system configuration menu items. See step 3d.
3. When turning on the power for a new machine, the LCD display directly enters the Installer Menu
at the [uC __] menu item, which is for selecting the user class as defined by UL. Select [uC 1] -
[uC 2] - [uC 3] or [uC 4] depending upon the use application.
4. Once the usage class is set, you should exit the Installer Menu, by pressing the Program Menu
button. The LCD display jumps to the close timer [Ct__] setting in the User menu, which may
now be set. Either press the Program Menu button again to exit to normal run mode or set the
close timer by the same programming sequence described on the previous page.
5. Note that you cannot exit the Installer menu until the selection for the UL usage class [uC __] has
been entered.
Test for normal function of the gate operator by running it both open and closed from the pushbuttons on
the membrane switch pad. It is best to verify normal function before the gate panel has been mounted.