12 SERVICE WORK ON THE CHASSIS
86
H03714-10
–
Fill bleeding syringe
4
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the slave cylinder, remove the protection cap and bleeder
screw
5
and mount bleeding syringe
4
.
H03715-10
–
Now press the fluid into the system until it emerges from the
hole
6
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws
bleeder screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
–
Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
12.44
Removing the engine guard
H01655-01
–
Remove screws
1
and engine guard.
12.45
Installing the engine guard
H01655-01
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis
M6
10 Nm (7.4 lbf ft)
