Husqvarna AUTOMOWER 105, Operator'S Manual

Page: 11 / 84

English - 11
1. INTRODUCTION AND SAFETY
Transport
The original packaging should be used when
transporting the robotic lawnmower over long
distances.
To safely move from or within the working area:
1. Press the STOP button to stop the robotic
lawnmower. If security is set to the medium or
high level (see
6.5 Security on page 52), the PIN
code has to be entered. The PIN code contains
four digits and is selected when you start the
robotic lawnmower for the first time. See
3.8 First
start-up and calibration
on page35.
2. Set the main switch in position 0 .
3. Carry the robotic lawnmower by the handle
found at the rear under the robotic lawnmower.
Carry the robotic lawnmower with the blade disc
away from the body.
Maintenance
• Inspect the robotic lawnmower each week and
replace any damaged or worn parts.
Check especially that the blades and blade disc
are not damaged. Check also that the blades can
pivot freely. Replace all blades and screws at the
same time if necessary so that the rotating parts
are kept balanced. See
8.7 Blades on page 64.
IMPORTANT INFORMATION
Do not lift the robotic lawnmower when it is
parked in the charging station. This may
damage the charging station and/or the
robotic lawnmower. Open the cover and
instead first pull the robotic lawnmower out
of the charging station before lifting it.
WARNING
When the robotic lawnmower is
turned upside down the main switch
must always be in the
0 position.
The main switch should be in the
0 position during all work on the
robotic lawnmower’s chassis, such
as cleaning or replacing the blades.
IMPORTANT INFORMATION
Never use a high-pressure washer or even
running water to clean the robotic
lawnmower. Never use solvents for cleaning.
3012-963
3012-1023
3012-1052