Husqvarna Viking Designer I, User Manual

Page: 74 / 117

74
Embroidery
Pop-up menus in Embroidery
Embroidery Start Up Calibration
As the embroidery unit is connected to the mach-
ine, a Pop-up menu prompts you to slide off the
hoop, and clear the machine area for positioning
of the embroidery arm. Touch OK to calibrate
the embroidery unit and to position the arm.
This menu also reminds you to use the R foot.
Top Thread Break
Your Designer I
USB
stops automatically if the top
thread runs out or breaks. Rethread the top th-
read, touch OK. Touch
to continue.
Empty Bobbin
Your
Designer I
USB
stops when the bobbin is
almost empty. Replace the empty bobbin with a
full one, touch OK (bobbin winding, see page
10).
Note: When changing the bobbin, touch and the
hoop will move away for easy access to the bobbin
case. Once the bobbin is replaced, touch
again to
move the hoop back to where em broi dery stopped.
Touch
to resume the embroidery.
Color Change
Your
Designer I
USB
stops automatically and the
top thread only is cut at the color change. Re-
move the spool and rethread the top with the
recommended color shown in the color menu
of the color touch screen or in the Embroidery
Booklet. Touch OK and
to resume embroi-
dering.
Cut Embroidery Top Thread Tail
Your Designer I
USB
stops automatically a few
stitches after you begin embroidering. Cut the
star ting thread tail, touch OK and
to resume
embroidering.
Wrong hoop for embroidery
When the size of the hoop on the machine does
not match the size displayed on the screen, your
Designer I
USB
will not sew. Change the hoop to
the size displayed on the screen.
Stop requested in design
Designer I
USB
stops when you are supposed to
do a cut work, applique etc. See explanation for
each design in the Embroidery Booklet.
Embroidery fi nished
When your embroidery is complete a pop-up
menu will appear. Touch OK to get back to your
embroidery.