Husqvarna Viking Designer I, User Manual

Page: 10 / 117

10
Learn your Designer I
USB
e
d
c
Threading for twin needle
1. Insert a twin needle. See page 16 “Changing
the needle”.
2. Use a second thread spool or wind a bobbin
with the thread you are going to use as the
second upper thread.
3. Left needle (blue). Thread the machine as
explained on page 9 (Vertical spol pin) and
check to ensure that thread lies between the
inner thread tension discs, inside the last
thread guide. Thread left needle.
4. Right needle (red). Pull up the extra spool
pin.
5. Place a spool holder and a felt pad under the
bobbin with the second thread on the spool
pin.
6. Thread the machine as before but this thread
should lie between the
outer thread tension
discs, outside the last thread guide. Thread
right needle.
Bobbin winding with the machine
threaded
Make sure that the presser foot and the needle
are in the up position. Use only the original
Husqvarna Viking green bobbins with your
Designer I
USB
.
Only use a metal presser foot when bob bin
winding from the needle.
1. Place your empty bobbin with the small mark
out on the bobbin spindle on the front of
the machine. Bring the bobbin spindle down.
A Pop-up menu on the Color Touch Screen
reminds you that bobbin winding is engaged.
2. Pull the thread from the needle under the
presser foot and to the right under the thread
guide (c) and over (d).
3. Start from above and wind a few turns of
thread clockwise around the bobbin. Cut off
the thread on the thread cutter (e).
4. Press the foot control or touch . When
the bobbin is fi lled, the winding will stop au-
tomatically. Remove the bobbin, cut off the
thread (e) and bring the bobbin spindle up.
Note: We do not recommend winding specialty
threads such as invisible or other stretchy threads
through the needle. Instead see “Bobbin winding
– vertical spool pin”.