Hunter GSP9700 Series, Operation Instructions Manual

Page: 43 / 157

Spacers
Hub Ring Spacers
These light truck spacers are designed to build a larger pocket when using extra
large truck cones. It also provides a location for the centering pins found on some
dual wheel configurations.
Shaft Spacers
The shaft spacer can be used to make the cone contact the hub bore more firmly.
For example, one cone size is too small because the captivated spring is not
pressing the cone against the inner wheel opening, but the next larger cone size is
too large and will not fit the opening. Use the smaller cone size, with the spacer, to
extend the captivated spring and hold the smaller mounting cone against the wheel
opening with greater pressure.
3.5 Hood Autostart Feature
The balancer can be set to automatically spin the wheel upon hood closure. After a
spin, the hood must be lifted completely before the balancer will Autostart again.
For safety, the balancer will not Autostart in “Calibration,” “Setup,” “Diagnostics,” if no
balancing procedure is selected, or if the Inflation Station hose is out of its “home
position.”
The hood close Autostart feature can be enabled or disabled in the “Setup”
procedure.
Refer to “Setting Up the Hood Autostart Feature,” page 113.
3.6 Loose Hub Detect Feature
When the GSP9720JLR senses that the wheel is loose, it will automatically stop the
spin. You should tighten the wing nut before proceeding.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
x
35