OPERATION
18
Operate the Shading
A single control is used to operate both the front window shading and the rear roller shade.
Operation is sequential. The front shading must be lowered and the vanes opened before the
rear roller shade can be lowered. Conversely, the rear roller shade must be raised before the
vanes on the front shading can be closed and the front shading raised.
CAUTION:
When raising the front shading or rear shade for the first time, observe how the
fabric rolls up into the headrail. It should roll up evenly. If the bottom rail is not level or the
fabric starts to rub against either window jamb, immediately stop the front or back shade from
operating. See “Adjust the Bottom Rail Weight of the Front Shading” on page 31.
■
For operation instructions, refer to the appropriate page based on your operating system.
➤
For the UltraGlide
®
➤
For the SoftTouch
®
Motorization system, see page 20.
➤
For the PowerView
®
Automation system, see page 22.
Shown below are a few examples of possible front shading and rear shade positions.
Front shading lowered with vanes
open, rear roller shade partly raised.
Vanes must remain open.
Front shading lowered with vanes
open, rear roller shade raised.
Vanes may only be operated in
this position.
Front shading lowered with vanes
open, rear roller shade lowered.
Vanes must remain open.
Summary of Contents for Silhouette DuoLite
Page 43: ......
