OPERATION
35
Problem
SoftTouch
®
only:
The shading limits need to be adjusted. (continued)
Solution
Adjust the Lower Limit — available for Rear Shade only.
Vanes Closed and Vanes Open Limits are also set.
All three limits must be set in sequential order when in programming mode.
The mechanical limit is when the rear shade is at the maximum fully closed
(down) position.
If the mechanical limit is reached while the rear shade is being adjusted, the
mechanical limit will automatically become the lower limit.
NOTE:
Programming mode timeout is 20 seconds. If there is no action within
20 seconds, programming mode exits.
Adjust the Lower Limit
■
Move the front shading and rear shade to the fully closed (down) position.
Vanes are fully open. See “Basic Operation” on page 20.
■
Programming Mode — In two motions: pull the wand down and release,
and quickly pull the wand down and hold. After approximately 6 seconds
the shading will beep and a red LED behind the activator arm will blink
continuously to indicate programming mode.
■
Release the wand. The lower limit is ready to be adjusted.
IMPORTANT:
For the following step, if you pull the wand down, it will
set the bottom limit at the fully down position (mechanical limit) and then
automatically go to the vanes closed position for adjustment.
■
Push the wand up and release to move the rear shade up. When the
desired lower limit location is reached, stop the rear shade.
■
Pull the wand down and hold for approximately 6 seconds until the rear
shade moves slightly twice (up, down or down, up).
■
Release the wand. The rear shade movement indicates the new lower limit
is set.
■
The rear shade moves to the fully open position and the front shading
moves to the vanes closed position.
(continued on next page)
Summary of Contents for Silhouette DuoLite
Page 43: ......
