INSTALLATION
6
■
Attach the installation brackets using the screws provided.
NOTE:
Do not overtighten the screws. Check to ensure
the lever can be moved easily side to side. If the lever is
not moving easily, loosen the screws in one-eighth turn
increments until it can be moved easily.
IMPORTANT:
The front edges of the installation brackets
must be level and aligned to each other.
UltraGlide
®
Shading: Proceed to “STEP 3: Install the Shading” on page 10.
PowerView
®
and SoftTouch
®
Shadings: Proceed to “STEP 2: Mount the
Battery Wand, If Applicable” on page 8.
Mount the Installation Brackets — Outside Mount
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark each end of the headrail.
➤
Alternatively, measure the width of the headrail and use that width to mark the
headrail end points over the window opening.
■
Mark 2" from each of the headrail end marks for bracket location.
➤
If more than two installation brackets came with your order, space additional bracket(s)
between the two end brackets and mark their location. Mount into wood whenever
possible.
➤
For PowerView and SoftTouch shadings with battery wand, allow a minimum of 18"
between bracket centerlines for the battery wand/rechargeable battery wand.
■
Center the installation brackets on your marks and mark the location of the screw holes.
➤
A minimum 1" flat vertical height is required to mount the installation brackets.
➤
Position the top of the installation brackets at the
desired height of the shading. The brackets must be
level and aligned.
CAUTION:
The rear of the blocks/brackets must be flush
against a flat mounting surface. Do not mount brackets on
curved molding.
IMPORTANT:
Additional clearance is required for PowerView
and SoftTouch shadings with a headrail-mounted battery wand
or rechargeable battery wand. See “Additional Clearance with
Spacer Blocks” on page 7.
Lever
Window Opening
2"
2"
Headrail End Mark
Headrail End Mark
Summary of Contents for Silhouette DuoLite
Page 43: ......
