INSTALLATION
3
Installation Overview
To install your shading, you will need to perform the following four steps:
STEP 1:
Mount the Installation Brackets
STEP 2:
PowerView
®
and SoftTouch
®
Only: Mount the Battery Wand, If Applicable
STEP 3:
Install the Shading
STEP 4:
PowerView and SoftTouch Only: Connect the Power Source, If Applicable
STEP 1: Mount the Installation Brackets
■
The number of installation brackets required
varies with shading width, as shown in the table.
Width
Brackets Required
14" – 48"
2
48
1
⁄
8
" – 96"
3
96
1
⁄
8
" – 120"
4
Installation
Bracket
Importance of Limit Stops on Silhouette Window Shadings
Limit stops serve as the upper travel limit for the bottom rail, preventing it from rotating
around the fabric roll. Limit stops are located 6" from the ends of the headrail or are
centered on shadings less than 36" wide.
When a shading is made, the limit stops are adjusted according to the size of the fabric
roll. Occasionally, this adjustment changes during shipping or installation. If this happens,
problems can be fixed by readjusting the limit stops. See page 32 in the Troubleshooting
section if shading operation is difficult or if the bottom rail rotates around the fabric roll.
Shown below are the four possible positions of limit stops for large to small fabric rolls.
Large Fabric Roll
Small Fabric Roll
Summary of Contents for Silhouette DuoLite
Page 43: ......
