INSTALLATION
14
■
Mark the screw holes.
■
Drill the screw holes using a
3
⁄
32
” drill bit.
■
Attach the battery mount using the screws provided.
CAUTION:
Only use the screws provided with the battery mount, designed so that the
screws will install flush with the mount. Protrusion of the screws could result in either the
battery wand not attaching properly causing a failure to connect, or the wand falling out
of the mount. Do not over-tighten.
■
Connect the power cable from the motor side into the power socket on the rechargeable
battery mount.
NOTE:
With longer cables, wire retainers (not supplied) are recommended to secure
the cable.
Install the Battery Wand into the Battery Mount
NOTE:
The rechargeable battery wand ships fully charged, so it is ready to install out of the
package.
■
Match the direction of
the arrow on the
underside of the
battery wand with the
arrow on the battery
mount.
■
Insert the nose of the
battery wand into the
cavity of the battery
mount.
■
Push the battery wand flush into the mount until the battery snaps into place.
CAUTION:
Failing to insert wand properly may cause it to fall out of the mount, posing
an injury risk and potentially damaging the wand. Additionally, when mounting on a door,
closing the door with excess force may cause battery wand to dislodge from the mount,
also posing an injury risk and possibly damaging the wand.
SoftTouch
®
Shading: Proceed to “SoftTouch Only — Unpack the Wand and
Attach to Activation Arm”on page 17.
Powerview
®
Shadings: Proceed to “Operate the Shading” on page 18.
Battery Mount
Extension
Cable
(If Needed)
Power Cable
from Shading
Summary of Contents for Silhouette DuoLite
Page 43: ......
