Operation Manual – Login
Quidway S5600 Series Ethernet Switches-Release 1510
Chapter 3 Logging in through Telnet
Huawei Technologies Proprietary
3-13
Scenario
Authenticati
on mode
User type
Command
Command
level
The
user privilege level
level
command is executed, and the
service-type
command specifies
the available command level.
The
user privilege level
level
command is not executed, and
the
service-type
command does
not specify the available
command level.
Level 0
The
user privilege level
level
command is not executed, and
the
service-type
command
specifies the available command
level.
Determined
by the
service-typ
e
command
The
user privilege level
level
command is executed, and the
service-type
command does not
specify the available command
level.
Level 0
VTY users that
are
authenticated
in the
password
mode of SSH
The
user privilege level
level
command is executed, and the
service-type
command specifies
the available command level.
Determined
by the
service-typ
e
command
Note:
Refer to the corresponding modules in this manual for information about AAA, RADIUS,
and SSH.
3.4.2 Configuration Example
I. Network requirements
Assume that you are a level 3 AUX user and want to perform the following configuration
for Telnet users logging into VTY 0:
z
Configure the name of the local user to be “guest”.
z
Set the authentication password of the local user to 123456 (in plain text).
z
Set the service type of VTY users to Telnet.
z
Configure to authenticate users logging into VTY 0 in scheme mode.
z
The commands of level 2 are available to users logging into VTY 0.
z
Only Telnet protocol is supported in VTY 0.
