HP storageworks 2/32, Installation Manual

Page: 110 / 138

Manage Firmware Versions
110 Edge Switch 2/32 Installation Guide
If a problem occurs and a corresponding message displays, refer to the HP
StorageWorks edge Switch 2/32 Service Manual for specific information on
isolating the problem. If no error occurs, the Send Firmware confirmation
box displays, as shown in Figure 49 .
Figure 49: Send Firmware confirmation box
7. Click Yes . The Send Firmware dialog box displays.
As the download begins, a “
Writing data to FLASH
” message displays
at the top of the dialog box, followed by a “
Sending Files
” message.
This message remains as a progress bar travels across the dialog box to show
percent completion of the download. The bar progresses to 50% when the last
file is transmitted to the first CTP2 card. The bar remains at the 50% point
until the edge switch performs an Initial Program Load (IPL) (indicated by an
“
IPLing
” message).
During the IPL, the edge switch-to-HAFM server link drops momentarily and
the following occur at the Product Manager:
■ As the network connection drops, the edge switch Status table turns
yellow, the
Status field displays
No Link
, and the State field displays a
reason message.
■ The alert panel at the bottom of the navigation control panel displays a
grey square, indicating edge switch status is unknown.
■ Illustrated FRUs in the Hardware View page are removed, and then
displayed again as the connection is re-established.
After the IPL, a “
Synchronizing CTP2s
” message displays. This
message remains as files are transmitted to the second CTP2 card and the
progress bar travels across the dialog box to 100%. When the download
reaches 100%, a “
Send firmware complete
” message displays.
8. Click Close to close the dialog box.
9. Click Close .