Hardware options installation 37
4.
Remove the access panel (on page
19
).
5.
Remove the PCI riser cage (on page
20
).
6.
Install the storage controller ("
Installing a storage controller
" on page
38
).
7.
Connect the common end of the Mini-SAS Y-cable to the controller option.
8.
Install the PCI riser cage (on page
21
).
9.
Route the split ends of the Mini-SAS Y-cable along the side of the system board towards the front chassis,
and then connect the cable to the drive backplane.
10.
Secure the Mini-SAS Y-cable using the cable clip that came with the kit:
a.
Use the two vertical dash marks in front of the fan cage to position the clip correctly, and then attach
the cable clip.
b.
Secure the excess length of the Mini-SAS Y-cable in the cable clip.
11.
Connect the rest of the drive cables required in this drive configuration. For more information, see
"Storage cabling (on page
71
)."
12.
If you intend to use an FBWC module and capacitor pack, install these options now ("
Installing the
FBWC module and capacitor pack
" on page
39
).
13.
Install the access panel (on page
20
).
14.
Install the server into the rack ("
Installing the server into the rack
" on page
27
).
15.
Power up the server (on page
17
).
Summary of Contents for ProLiant DL360e Gen8
