HP Jetdirect J7974E, Administrator'S Manual

Page: 56 / 186

1 : disables multiple connections.
buffer-packing Enables or disables buffer packing for TCP/IP packets.
1 (default): is normal, the data buffer is packed before sending to the printer.
0 : disables buffer packing, data is sent to the printer as it is received.
write-mode Controls the setting of the TCP PSH flag for device-to-client data transfers.
0 (default): disables this option, flag is not set.
1 : all-push option. The push bit is set in all data packets.
TCP/IP LPD Queues
addq Adds a user-defined queue. The queue name (up to 32 displayable ASCII characters),
prepend string name, append string name, and processing queue (typically, RAW) must
be specified in the command line. Up to six user-defined queues may be added.
CAUTION Avoid the differentiation of queue names through the use of lower-
and upper-case characters only. Otherwise, management of LPD queues by other
tools may yield unpredictable results.
deleteq Delete a user-specified queue. The queue name must be specified in the deleteq command
line.
defaultq Name of the queue to be used if the queue specified for a print job is unknown. By default,
the default queue is
AUTO .
addstring Adds a user-defined character string that may be prepended or appended to print data.
Up to eight character strings may be specified. A string name and the character string
contents are specified in the addstring command line.
deletestring Deletes a user-defined string. The string name is specified in the deletestring command
line.
TCP/IP Raw Print Ports
raw-port Specifies additional ports for printing to TCP port 9100. Valid ports are 3000 to 9000, which
are application-dependent. Up to two ports can be specified.
TCP/IP Access Control
allow Makes an entry into the host access list stored on the HP Jetdirect print server. Each entry
specifies a host or network of hosts that are allowed to connect to the printer. The format
is “allow netnum [mask]” where netnum is a network number or host IP address, and mask
is an address mask of bits applied to the network number and host address to verify access.
Up to 10 access list entries are allowed. If there are no entries, all hosts are permitted
access. For example,
allow 192.0.0.0 255.0.0.0
— allows hosts on network 192.
allow 192.168.1.2
— allows a single host. In this case, the default mask
255.255.255.255 is assumed and is not required.
allow 0
— clears the host access list.
For additional information, see Security Features (V.34.xx) .
TCP/IP Other
syslog-config Enables or disables syslog server operation on the print server: 0 disables, 1 (default)
enables. (UDP port 514)
Table 3-3 Telnet Commands and Parameters (continued)
46 Chapter 3 TCP/IP Configuration ENWW