HP Jetdirect J7974E, Administrator'S Manual

Page: 144 / 186

Error Code and Message Description
4A CF ERR - UNKNOWN
KEYWORD A TFTP configuration file line contained an unknown keyword.
4B CF ERR - MISSING
PARAMETER A line in the TFTP configuration file was missing a required parameter.
4C CF ERR - INVALID PARAMETER A line in the TFTP configuration file contained an invalid value for one of the parameters
on that line.
4D CF ERR - ACCESS LIST
EXCEEDED The TFTP configuration file specified too many access list entries using the “allow:”
keyword.
4E CF ERR - TRAP LIST
EXCEEDED The TFTP configuration file specified too many trap destination list entries using the
“trap-destination:” keyword.
4F TFTP REMOTE ERROR The TFTP transfer of the configuration file from the host to the HP Jetdirect print server
failed with the remote host sending a TFTP ERROR packet to the print server.
50 TFTP LOCAL ERROR The TFTP transfer of the configuration file from the host to the HP Jetdirect print server
failed with the local print server encountering some form of inactivity timeout, or
excessive retransmissions situation.
51 TFTP RETRIES EXCEEDED The overall retrying of the TFTP transfer of the configuration file from the host to the HP
Jetdirect print server has exceeded a retry limit.
52 BAD BOOTP/DHCP REPLY An error was detected in the BOOTP or DHCP reply that the HP Jetdirect print server
received. The reply either had insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an operation field that was not
BOOTPREPLY(0X02), had a header field that did not match the print servers hardware
address, or had a UDP source port that was not the BOOTP/DHCP server port (67/udp).
53 BAD BOOTP TAG SIZE The tagsize in a vendor-specific field in the BOOTP reply is either 0, or greater than the
remaining number of unprocessed bytes in the vendor-specified area.
54 BOOTP/RARP IN PROGRESS The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/RARP.
55 BOOTP/DHCP IN PROGRESS The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/DHCP, and has not detected any errors.
56 DHCP NAK The HP Jetdirect print server received a negative acknowledgement message from the
DHCP server in response to a configuration request.
57 UNABLE TO CONNECT DHCP
SVR The HP Jetdirect print server had received IP parameters from a DHCP server, but
communication with the DHCP server has been lost. Check status of the DHCP server.
If an infinite lease was assigned, the print server will use the IP address of the most
recent DHCP server used, but operation may be degraded until a DHCP server
responds.
58 POSTSCRIPT MODE NOT
SELECTED The printer does not support AppleTalk or AppleTalk extensions.
59 INCOMPLETE F/W - MUST
DOWNLOAD Firmware download message. Currently downloading firmware to the HP Jetdirect print
server, or the download did not complete properly.
5A TURN PRINTER OFF / ON Firmware download message. Download of firmware is complete. Power off/on the HP
Jetdirect print server.
5C DHCP BAD REPLY A bad reply was received from the DHCP server. Check your DHCP server settings for
this print server.
5D DHCP LEASE DURATION TOO
SHORT The DHCP lease times for this print server's TCP/IP configuration settings are too short.
Reconfigure the DHCP lease times on the DHCP server.
Table 8-12 Error Messages (continued)
134 Chapter 8 HP Jetdirect Configuration Pages ENWW