HP Jetdirect J7974E, Administrator'S Manual

Page: 174 / 186

Menu Item Submenu Options Additional Options Description of settings
●
PING IN PROGRESS: Displays whether or not a
ping test is in progress. YES indicates a test in
progress, and NO indicates that a test completed or
was not run.
●
REFRESH: When viewing the ping test results, this
item updates the ping test data with current results.
Select YES to update the data, or NO to maintain
the existing data. However, a refresh will
automatically occur when the menu times out or you
manually return to the main menu.
LINK SPEED AUTO
10T HALF
10T FULL
100TX HALF
100TX FULL
100TX AUTO
1000TX FULL
The link speed and communication mode of the print
server must match the network. The available settings
depend on the printer and installed print server. One of
the following link configuration settings can be selected:
CAUTION If you change the link setting,
network communications with the print server
and network device may be lost.
AUTO (default): The print server uses auto-negotiation
to configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails,
either 100TX HALF or 10TX HALF is set depending on
the detected link speed of the hub/switch port. (A 1000T
half-duplex selection is not supported.)
10T HALF : 10 Mbps, half-duplex operation.
10T FULL : 10 Mbps, Full-duplex operation.
100TX HALF : 100 Mbps, half-duplex operation.
100TX FULL : 100 Mbps, full-duplex operation.
100TX AUTO : Limits auto-negotiation to a maximum link
speed of 100 Mbps.
1000TX FULL : 1000 Mbps, full-duplex operation.
PRINT
PROTOCOLS Use this item to print a page containing the configuration
of the following protocols: IPX/SPX, Novell NetWare,
AppleTalk, DLC/LLC.
Table C-1 HP Jetdirect Control Panel Menu (continued)
164 Appendix C The HP Jetdirect Control Panel Menu (V.34.xx) ENWW