267
Specify the device to try up to 5 times at an interval of 5 seconds in transmitting a packet to the
RADIUS server until it receives a response from the server, and to send real time accounting packets
to the accounting server every 15 minutes.
Figure 276 Network diagram
Configuring IP addresses
# Assign an IP address to each interface as shown in
. Make sure the supplicant, switch,
and servers can reach each other. (Details not shown.)
Configuring the RADIUS servers
For more information about the RADIUS configuration, see "
."
Configuring 802.1X for the switch
1.
Configure global 802.1X:
a.
From the navigation tree, select
Authentication
>
802.1X
.
b.
Select
Enable 802.1X
, select the authentication method as
CHAP
, and click
Apply
.
Figure 277 Configuring 802.1X globally
2.
Configure 802.1X for GigabitEthernet 1/0/1:
a.
In the
Ports With 802.1X Enabled
area, click
Add
.
b.
Select
GigabitEthernet1/0/1
from the
Port
list, select
Enable Re-Authentication
, and
click
Apply
.
Summary of Contents for FlexNetwork NJ5000
