96
5.
Click
Add
.
The page for adding a target host of SNMP traps appears.
Figure 96 Adding a target host of SNMP traps
6.
Configure the settings for the target host as described in
7.
Click
Apply
.
Table 44 Configuration items
Item Description
Destination IP
Address
Set the destination IP address.
Select the IP address type: IPv4 or IPv6, and then type the corresponding IP
address in the field according to the IP address type.
Security Name
Set the security name, which can be an SNMPv1 community name, an
SNMPv2c community name, or an SNMPv3 user name.
UDP Port
Set UDP port number.
IMPORTANT:
The default port number is 162, which is the SNMP-specified port used for
receiving traps on the NMS. Generally (such as using IMC or MIB Browser as
the NMS), you can use the default port number. To change this parameter to
another value, you need to make sure the configuration is the same with that
on the NMS.
Security Model
Select the security model, for which you must set the SNMP version. For the
NMS to receive notifications, make sure the SNMP version is the same with
that on the NMS.
Security Level
Set the authentication and privacy mode for SNMP traps when the security
model is selected as
v3
. The available security levels are: no authentication
no privacy, authentication but no privacy, and authentication and privacy.
When the security model is selected as
v1
or
v2c
, the security level is no
authentication no privacy, and cannot be modified.
Displaying SNMP packet statistics
Select
Device
>
SNMP
from the navigation tree.
Summary of Contents for FlexNetwork NJ5000
