HP EVA P6000, User Manual

Page: 247 / 298

D Using the iSCSI CLI
The CLI enables you to perform a variety of iSCSI or iSCSI/FCoE module management tasks through
an Ethernet or serial port connection. However, HP P6000 Command View should be the primary
management tool for the iSCSI and ISCSI/FCoE modules. The CLI is a supplemental interface.
Logging on to an iSCSI or iSCSI/FCoE module
You can either use Telnet or Secure SHell (SSH) to log on to a module, or you can log on to the
switch through the serial port. To log on to the module using Telnet:
1. On the workstation, open a command line window.
2. Enter the telnet command followed by the IP address:
= telnet <ip address>
NOTE: This is the management port IP address of either iSCSI controller 01 or 02, and may
be a static IP, a DHCP provided IP, or a default static IP.
A Telnet window opens and prompts you to log in.
3. Enter an account name and password.
To log on to a module using SSH:
NOTE: SSH works in a way similar to Telnet, except it uses ROSA to encode transmissions to
and from your workstation and the HP iSCSI or iSCSI/FCoE module.
1. On the workstation, open a command line window.
2. Enter the
ssh
command followed by the module mgmt port IP address:
# ssh <ip address>
An SSH window opens and prompts you to log in.
3. Enter an account name and password.
To log on to a switch through the serial port:
1. Configure the workstation port with the following settings, using an RJ45 to DB9 dongle (HP
spares part number 663678–001) and a standard RJ45 Ethernet cable:
•
115200 baud
•
8-bit character
•
1 stop bit
•
No parity, and flow control—none
2. When prompted, enter an account name and password (typically,
guest
and
password
).
Understanding the guest account
iSCSI and iSCSI/FCoE modules come from the factory with the guest account already defined.
This guest account provides access to the module and its configuration. After planning your
management needs, consider changing the password for this account. For information about
changing passwords, see the
“passwd command” (page 210) . The guest account is automatically
closed after 15 minutes of inactivity. For example:
login as: guest
guest@172.17.136.86's password: *********
******************************************************
* *
* HP StorageWorks MEZ50 *
* *
******************************************************
MEZ50 (admin) #> show system
Logging on to an iSCSI or iSCSI/FCoE module 247