6 Upgrading and servicing the Tape Autoloader
WARNING!
The HP StorageWorks 1/8 G2 Tape Autoloader weighs 11.5 kg (25.4 lb) without
media and 13.1 kg (28.9 lb) with media (8 cartridges). When moving the Autoloader, to reduce
the risk of personal injury or damage to the Autoloader: 1) observe local health and safety
requirements and guidelines for manual material handing, 2) always remove all tapes to reduce
the overall weight of the Autoloader, and 3) obtain adequate assistance to lift and stabilize the
Autoloader during installation or removal.
WARNING!
To reduce the risk of personal injury or damage to equipment:
•
Extend leveling jacks to the floor.
•
Ensure that the full weight of the rack rests on the leveling jacks.
•
Install stabilizing feet on the rack.
•
Extend only one rack component at a time. Racks may become unstable if more than one
component is extended.
CAUTION:
A discharge of static electricity can damage static-sensitive devices or microcircuitry.
Proper packaging and grounding techniques are necessary precautions to prevent damage.
To prevent electrostatic damage, observe the following precautions:
•
Transport products in static-safe containers such as conductive tubes, bags, or boxes.
•
Keep electrostatic-sensitive parts in their containers until they arrive at static-free stations.
•
Cover the device with approved static-dissipating material. Provide a wrist strap connected
to the work surface and properly grounded tools and equipment.
•
Keep the work area free of nonconducting materials, such as ordinary plastic assembly aids
and foam packing.
•
Make sure you are always properly grounded when touching a static-sensitive component or
assembly.
•
Avoid touching pins, leads, or circuitry.
•
Use conductive field service tools.
CAUTION:
Before moving the Autoloader, remove all media. During a move, the cartridges could
come out of the storage slots and damage the Autoloader.
Possible tools needed
To service the Autoloader you may need one or more of the following tools:
•
Flat-blade screwdrivers (large and small)
•
Short-handle #1 Phillips screwdriver
•
#2 and #3 Phillips screwdrivers
•
Ground strap
•
Paper clip or pin (for manual magazine removal)
•
HP Library and Tape Tools (L&TT) diagnostic software
130 Upgrading and servicing the Tape Autoloader
Summary of Contents for BL536A
Page 149: ...German laser notice Italian laser notice Japanese laser notice Laser compliance notices 149 ...
Page 151: ...Danish notice Dutch notice Estonian notice Finnish notice French notice Recycling notices 151 ...
Page 155: ...French battery notice German battery notice Battery replacement notices 155 ...
Page 156: ...Italian battery notice Japanese battery notice 156 Regulatory compliance and safety ...
