HP BL536A, User'S & Service Manual

Page: 125 / 165

Table 36 Warning event codes (continued)
Details and Solution Description Event code
Drive firmware is specific to the drive model and
interface. Select the drive firmware specific to this Wrong drive firmware — invalid drive firmware
type. 5D
drive. If the firmware file could have been
renamed, obtain a new copy of the firmware file
The device firmware may not be downgraded in
cases that would compromise encrypted data, No firmware downgrade possible. 5F
critical component support, or license terms. Check
the configuration settings. If the device has been
using the Encryption Kit, you may need to disable
encryption before downgrading firmware.
Complete the cleaning process and retry the
operation. Cleaning tape installed. 60
Cleaning failure. Cleaning process could not be
performed. 61 •
Check cleaning tape and exchange if
necessary.
•
Retry the operation.
Exchange the cleaning tape. Cleaning tape expired. 62
Invalid cartridge. Drive has rejected the cartridge
as invalid. 63 •
Verify that the cartridge generation and
technology are supported by the device. See
Tape cartridges (page 30) .
Invalid cleaning cartridge. Drive has rejected the
cartridge as invalid. 64
•
Retry the operation.
•
If problems persist, exchange the data
cartridge.
Invalid upgrade cartridge. Drive has rejected the
cartridge as invalid. 65 •
Retry the operation.
•
If problems persist, exchange the data
cartridge.
The diagnostic test needs to write data but the tape
being used for the test is write protected. Ensure Diagnostic tape write protect. 66
that the device has a tape that is not write
protected for use during the diagnostic test.
The drive tried to read or write data from a tape
from an incompatible LTO generation. For Incompatible medium 67
compatibility information see Backward read
compatibility (page 33) .
Check the SCSI cable connection and verify that
the maximum cable length is not exceeded. Verify
that the SCSI bus is properly terminated. SCSI message error 70
SCSI parity error 71
SCSI invalid message 72
The application software made an illegal request. SCSI: overlapped command attempt 73
SCSI: echo buffer overwritten 74
Recovered error move operation. No action
required. Occasional retries are normal operation. Movement retry. Robotics movement did not
succeed but was successful on a retry. 80
•
Check the tape drive fan on the Autoloader
back panel to see whether the fan is
operational and not obstructed.
NOTE: Fan only operates when cooling is
required.
Drive sled fan alert. Fan motion has stopped. 81
Clean the tape drive using a valid cleaning tape. Clean request from the tape drive 82
Warning events 125