Installing the HP UPS Power Protection Agent 39
3.
From the directory that contains all five files, run
./SetupRA -s -f DevManRA.ini
to install
silently.
If the .ini file is not located in the same folder as the SetuprRA file, run
./SetupRA -s -f
<path> DevManRA.ini,
where <path> is the
DevManRA.ini
file location.
The following command line parameters can be specified and are applicable for both interactive and
silent modes.
Parameter Function
-s
Performs a silent install.
-l
Creates an installation log
(opt/DevMan/install.log). Default is disabled for
interactive mode and enabled for silent mode. The
installation log is created automatically for
Windows® during silent installations in
\%systemdrive%\setup.log.
-f DevManRA.ini
Specifies a configuration .ini file used for clean
installs. When this option is specified, the device
detection and configuration step is omitted.
Reconfiguring the agent on HP-UX operating systems
To reconfigure the management module IP address or serial path, run
/sbin/init.d/DevMan setup
.
Uninstalling components from Windows® systems
1.
Click
Start>Settings>Control Panel.
2.
Open
Add/Remove Programs.
3.
Select
UPS Power Protection Agent,
and then click
Change/Remove.
The uninstall wizard launches.
Select
Remove Choice,
and then click
Next.
4.
Follow the prompts in the uninstall wizard to uninstall the software.
NOTE:
Some files might remain following the uninstallation and can be removed manually.
Uninstalling components from Linux systems
Execute the uninstall script (
./Uninstall
).
NOTE:
Some files might remain following the uninstallation and can be removed manually.
Uninstalling components from HP-UX systems
Execute the uninstall script (
./Uninstall
).
