HP 8590 E-Series, Calibration Manual

Page: 661 / 693

Amplitude Characteristics
Input 1 Input 2 Bypass
Displayed A verage Noise Level
400 kHz
(Input terminated, 0 dB attenuation, 30 Hz IF BW ,
30 Hz A vg BW , sample detection)
Preamp O < 031 dBV < 031 dBV < 018 dBV
Preamp On < 039 dBV < 039 dBV
Second Harmonic Intercept
*
1 MHz < f < 1 GHz
Preamp O > 122 dBV > 122 dBV
Preamp On > 110 dBV > 110 dBV
Third Order Intercept
y
> 10 MHz
Preamp O > +98 dBV > +98 dBV > +5 dBV
Preamp On > +89 dBV > +89 dBV
Residual Responses (Input terminated, 0 dB attenuation, Preamp On except
in Bypass)
> 150 kHz < +10 dBV < +10 dBV < 017 dBV
Input VSWR
0 dB input attenuation < 2:1 < 2:1 < 3:1
10 dB input attenuation
100 kHz to 1 GHz < 1.2:1 < 1.2:1 < 2:1
> 1 GHz < 1.6:1 < 1.6:1 < 2:1
*
Indicated characteristic was derived from measured harmonic levels for a 040 dB input
signal.
y
Signal separation > 50 kHz. Indicated characteristic was derived from measured distortion
products for
two +77 dBV CW signals at the input.
Other Input Related Spurious
*
< 065 dBc
* 30 kHz oset for +87 dBV tone at the mixer the maximum frequency range limit of the EMC
analyzer
y
,
f > 10 MHz.
P ower at the input mixer = input power 0 input attenuation + RF lter section amplication
y Refer for the \Frequency Range" table in this section for the maximum frequency range of the
EMC analyzer .
9-10 Characteristics for the EMC Analyzer
with the RF Filter Section