HP 8590 E-Series, Calibration Manual

Page: 160 / 693

22. Frequency Response , HP 8595EM
22. Frequency Response ,
HP 8595EM
This performance verication test must be performed with the EMC analyzer set
in the spectrum analyzer mode.
The output of the synthesized sweeper is fed through a power splitter to a
power sensor and the EMC analyzer . The synthesized sweeper power level
is adjusted at 300 MHz to place the displayed signal at the analyzer center
horizontal graticule line . The measuring receiver , used as a power meter , is
placed in RA TIO mode . At each new synthesized sweeper frequency and
analyzer center frequency setting, the synthesized sweeper power level
is adjusted to place the signal at the center horizontal graticule line . The
measuring receiver displays the inverse of the frequency response relative to
300 MHz (CAL OUT frequency).
Equipment Required
Synthesized sweeper
Measuring receiver (used as a power meter)
Synthesizer/Level generator
P ower sensor , 50 MHz to 6.5 GHz
P ower splitter
T ermination, 50
A dapter , Type N (m) to APC 3.5 (m)
A dapter , Type N (f) to BNC (f)
A dapter , 3.5 mm (f) to 3.5mm (f)
A dapter , Type BNC (f) to SMA (m)
Cable , BNC, 122 cm (48 in)
Cable , APC 3.5, 91 cm (36 in)
P erformance V erication T ests 2-131