HP 8360, User Handbook Manual

Page: 479 / 508

Inputs Outputs RF
output
Nominal output inpedance ohms mm male on 20 and 26.5 models,
for negative external defector or power meter Nominal input impedance
kohms, damage volts. RF Output female,
Pulse
signal turns RF When using
the
standard internal pulse a
connector Nominal input 50 ohms, damage level -05 volts See
Modulation front
AM
Nominal input impedance 50 ohms
switchable to 2 kohms), damage level
volts See Modulation front panel.)
Nominal input impedance 50 ohms (internally switchable to 600 ohms), damage level
volts. See female, front panel.)
Activated on a rising edge. Used to
initiate an analog
or to advance
to the next point in step or list mode. Damage level -0.5 volts. female, rear
output
Outputs a pulse at 1601 points evenly spaced across an
analog or at each point in step or list mode. female, rear panel.)
10 Input
Accepts 10 100 0 to + 10 signal for operation from external time
Nominal input impedance 50 ohms. Damage level + 10, -5 female, rear
10 Reference Output
Nominal signal level 0 nominal output impedance 50 ohms. female, rear
sweep output
Supplies a voltage
to the sweep ranging from 0 volts at start of to
to percentage of full instrument range. Minimum load impedance 3 kohms.
Sweep will stop when extemally. while when
(approximately
Supplies voltage to output at 05 (internally
to or output volts Minimum load 2 kohms
mv, typical. female, rear
-Module
bias, flatness correction, and to
Modules (Special, front and rear
Change A
HP 8360
User’s Handbook