HP 8360, User Handbook Manual

Page: 117 / 508

Use of the Command Tables
In Table 1-4, notice that a new column titled “Allowed Values” has
been added to the command table. This column lists the specific
values or range of values allowed for each parameter. A vertical
bar
separates values in a list from which you must choose one
value. The commands listed in the table are only part of all the
available SCPI commands of the synthesizer. For a complete listing
of the programming codes see “SCPI Command Summary” in the
Operating and Programming Reference chapter that follows.
Table 1-4. Sample Synthesizer Commands
Command Parameters Parameter Type Allowed Values
flatness array
to cal
discrete
measured power extended numeric [lvl suffix]
801
correction pairs extended numeric <num> suffix],
center freq
CW freq
coupled to
center freq
extended numeric
extended numeric
Boolean
specified freq
range
specified freq range
or
free mode
start freq
discrete
extended numeric specified freq range
or
auto freq step Boolean
freq step extended numeric 20 to 0.01 or
stop freq extended numeric specified freq range
or
MARKer[n]
marker frequency extended numeric
[n] is 1 to 5, 1 is the default
specified freq range
or
Getting Started Programming 1-87