HotBrick Network Solutions
Settings – Load Balance
Load Balance
Configuration
•
Enable
– Use this to enable your Load Balance settings. Unless this is
checked, the other settings on this screen have no effect.
•
Balance Type
– Select the desired option:
•
Bytes rx+tx – Traffic is measured by Bytes.
•
Packets rx+tx – Traffic is measured by Packets.
•
Sessions established – Traffic is measured by Sessions.
•
IP Address – Traffic is measured by IP Address.
•
Loading Share on WAN 1
– Enter the percentage (%) of traffic to be sent
over WAN 1. If one WAN port connection has greater bandwidth than the
other, the one with the greater bandwidth should be given a higher percentage
of traffic than the other.
Click the "Update" button to save your changes.
NAT
Statistics
This section displays the current data about WAN 1 and WAN 2. You can use this
information to help you "fine-tune" the settings above.
Interface
Statistics
This section displays cumulative statistics.
Use the "Restart Counters" button to restart these counters when required.
Buttons
•
Update
– Save the settings on this screen.
•
Refresh
– Update the data on screen.
•
Restart Counters
– Restart the counters used in the "Interface Statistics"
section.
Page 21
Summary of Contents for VPN 800/2
Page 1: ...Dual WAN Firewall Router VPN 800 2 User s Guide HotBrick Network Solutions ...
Page 2: ......
Page 55: ...HotBrick Network Solutions IPSec Global Setting Figure 6 1 IPSec Global Setting Page 51 ...
Page 57: ...HotBrick Network Solutions Policy Setup Policy Setup Figure 6 2 Policy Setup Page 53 ...
