HotBrick Network Solutions
2. Installing the HotBrick VPN 800/2 Firewall Router in your LAN
1. Ensure the HotBrick VPN 800/2 Firewall Router and the DSL/Cable modem are powered OFF.
Leave the modem or modems connected to their data line.
2. Connect the Broadband modem or modems to the VPN 800/2 Firewall Router.
•
If using only one (1) Broadband modem, connect it to the "WAN 1" port.
•
Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a
standard cable.
3. Use standard LAN cables to connect PCs to the Switching Hub ports on the VPN 800/2 Firewall
Router.
•
Both 10BaseT and 100BaseT connections can be used simultaneously.
•
If you need to connect the VPN 800/2 Firewall Router to another Hub, just use a standard
LAN cable to connect any port on the VPN 800/2 Firewall Router to a standard port on
another hub. Any LAN port on the VPN 800/2 Firewall Router will automatically act as an
"Uplink" port when required.
4. Power
Up
•
Power on the Cable or DSL modem or modems.
•
Connect the supplied power cord to the VPN 800/2 Firewall Router and power up.
5. Check the LEDs
•
The
Power
LED should be ON.
•
The
WAN – Link
LED should be ON, if the corresponding WAN port is connected to a
broadband modem.
•
The
Error
LED will flash during start up, but will then turn off. If it stays on, there is an error
condition.
•
For each PC connected to the LAN ports, the corresponding
LAN
LED (either
10
or
100
)
should be ON.
3. Configuring the HotBrick VPN 800/2 Firewall Router for Internet Access
Select
Primary Setup
from the menu, to see a screen like the example below.
•
Configure WAN 1 and/or WAN 2 as required.
•
For any of the following situations, refer to
Chapter 3: Advanced Port Setup
for any further
configuration, which may be required.
•
Using both ports
•
Multiple IP addresses on either port
•
Multiple PPPoE sessions
•
PPTP connection method
Page 12
Summary of Contents for VPN 800/2
Page 1: ...Dual WAN Firewall Router VPN 800 2 User s Guide HotBrick Network Solutions ...
Page 2: ......
Page 55: ...HotBrick Network Solutions IPSec Global Setting Figure 6 1 IPSec Global Setting Page 51 ...
Page 57: ...HotBrick Network Solutions Policy Setup Policy Setup Figure 6 2 Policy Setup Page 53 ...
