20
HobbyZone Super Cub • Instruction Manual
Throttle Adjustment
1. Fully increase throttle (100%) to launch your model.
2. Increase the throttle above half (50%) to make the model go up.
Note:
Increased wind speeds can both increase lift from the wing and
increase difficulty in turning the model.
3. When the model is above the ground where you want to fly, decrease throttle
to half for cruising. Half throttle lets you fly the model longer than when flying
the model at full throttle.
4. Decrease the throttle below half to bring the model down.
50%
50%
50%
Aerobatic Flight
An experienced pilot can safely make the Super Cub perform aerobatic maneu
-
vers (loops and stalls). The steps below describe adjusting the model for these
aerobatic maneuvers.
1. Make sure ACT is OFF.
2. Remove the clevises from the outermost holes in the control horns.
3. Install the clevises in the innermost holes of the control horns.
Note:
Changing the installation point of the clevises increases the control
throw (or range of motion) of the control surfaces. This makes the model
more sensitive to movement of the aileron (assigned to rudder control) and
elevator stick, so the model can stall more easily.
4. After moving a clevis, do a Control Test, center the control surface and adjust
trim.
Note:
Crash damage is not covered under warranty.
