7
HobbyZone Super Cub • Instruction Manual
Hi/Lo Rate
The DX4e offers a high/low rate function on aileron, elevator and rudder channels.
When the HI/LO rate switch is in the upper, or “HI” position, travel is 100% on
these channels. When the switch is in the lower, or “LO”, position, travel decreases
to 70% on these channels. This switch lets you quickly change control rates from
high for aggressive maneuvers to low for smooth, precise maneuvers.
You should fly the Super Cub at the low (70%) rate when you are first learning to
fly the Super Cub.
There may be a small amount of movement in the aileron and rudder (assigned
to the aileron channel) position on the Super Cub when you change rates. This is
caused by the trim switches on the DX4e and the amount of trim you set on each
channel. To decrease this movement, mechanically adjust the linkages on your
aircraft so the trims are as close to center (neutral) as possible.
Trainer
The DX4e offers a trainer function that allows the transmitter to operate as a
master or slave. Refer to the transmitter manual for more information. Using the
trainer function is helpful for new pilots wanting the assistance of an experienced
pilot when learning to fly the Super Cub.