11
HobbyZone Super Cub • Instruction Manual
Install Landing Gear
1. Turn over the fuselage to see the slot on the bottom of the fuselage.
2. Hold the landing gear wire with your hand near the wheels and squeeze the
landing gear wire “legs”.
3. Slide the loop into the slot on the bottom of the fuselage. Release the wire
“legs” of the landing gear.
4. Pull on the gear a small amount to make sure the gear is fully installed.
5. Attach 2 white covers to fuselage using 4 screws. The covers are marked L
and R for the correct sides of the fuselage. A small bag labeled “A” holds the 4
screws.
NOTE:
Small rubber bands hold the covers on the landing gear.
Attach Wing
1. Align the center of the wing on the top of the fuselage.
2. Put a band over the wing, front post to back post (illustration 1), on each side
of fuselage.
3. Put bands from the front posts and over the wing to the back posts on the
opposite sides of the fuselage (illustration 2).
4. Turn over the wing and fuselage to attach left and right struts
(marked L and R) under the wing and fuselage.
5. Put strut hooks in loops under wing.
Note:
The slotted washer which holds a strut loop in the wing may
become loose from the wing.
6. Attach the struts to the fuselage using 2 screws from a small bag labeled “B.”
Before each flight, make sure the wing is attached correctly to the fuselage.
1
1
3
2
2
4
