horiba LAQUA 2000 Series, Instruction Manual

Page: 56 / 108

Conductivity Setup
38
● P1 COND Setup
Using conductivity setup, you can:
• Set cell constant
• Select conductivity unit
• Select calibration method
• Set temperature coefficient
• Set reference temperature
• Erase calibration data
To set the conductivity function of EC2000 or PC2000 meter, follow the procedure detailed
below:
Prerequisites
• Switch on the meter.
• Ensure that the meter is in conductivity measurement mode.
• Default cell constant value is 1.0000. You can set a value in between 0.0700 to 13.000 .
• Default conductivity unit is S/cm . You can change the unit to S/m .
• Default auto calibration setup is ON . To perform manual calibration, change the setup to
OFF .
• Default temperature coefficient is 2.00%. You can set a value in between 00.00% to
10.00% .
• Default reference temperature is 25.0°C . You can set the value in between 15.0°C to
30.0°C.
• Erasing previous calibration data is recommended for accurate calibration. Default
calibration clear setup is NO but to erase the calibration data, change the setup to YES .
To return to the measurement mode, press the key.
Note
Tip