Rev. D
71
KDMU000799
02/6/04
SECTION 10:
OPERATION USING AMERICAN DYNAMICS CONTROL SYSTEM
10.1 INTRODUCTION
NOTE:
•
Refer to
Section 6
(operation) and
Section 7
(programming) when using standard protocol.
Operation and programming when using iPro protocol
is the same as standard protocol.
•
Refer to
Section 8
(operation) and
Section 9
(programming) when using Maxpro, Pelco P Code,
Pelco D Code, Burle, or VCL control systems.
This section provides information on any differences to the material provided for
standard protocol and provides information specific to operation American Dynamics
control systems. Operation of the unit is the same as described in
Section 6
, with the
following statements. The section number corresponds to the numbering in Section
6. Therefore, Section 10.3 provides additional or replacement information to that in
Section 6.3.
10.2 RESET KD6i
No changes or supplemental instructions are required. Refer to
Section 6.2
.
10.3 CONTROLLING SCAN ASSEMBLIES
•
When using an American Dynamics control system, there are several PreShots
(views or presets) reserved for controlling the scan. Refer to
Table 3
for a listing
of the preprogrammed PreShots and their functions.
•
The lens iris is automatically controlled by the camera, but can be controlled
manually from a controller.
•
The camera lens auto exposure mode can be enabled or disabled using the
controller.
PreShot 64
toggles the unit between auto and manual exposure. A
message “AUTO EXPOSURE ON” or “AUTO EXPOSURE OFF” is displayed on
the video when the scan executes PreShot 64.
•
Manual lens exposure control is the factory default for scans set for an American
Dynamics control system.
