Rev. D
54
KDMU000799
02/6/04
7.2 PROGRAMMING
PRESHOTS
A PreShot is a predefined scan and lens position (including the pan, tilt, zoom, and
focus settings, and, in some modes, iris settings).
•
A PreShot is saved with a number and title.
•
The operator uses the PreShot number to send the scan unit to the PreShot.
•
The PreShot title can be enabled or disabled.
•
The location of the PreShot title on the monitor display is programmable.
•
If the camera ID is enabled, the letter A for automatic operation appears next to
the camera number display on the monitor whenever the scan has been sent to a
PreShot.
A total of 98 (00-97) PreShot positions are programmable per unit with the PreShots
stored on the receiver board. If an 843216-1011 or 843216-1013 camera is installed,
PreShot 99 is reserved for toggling the NightShot mode on and off. PreShot 98 is
reserved for the camera reset function.
NOTE:
PreShots can also be programmed using the
PRGM
key on the JPD
controller. However, a specific title cannot be programmed using the
PRGM
key. See the JPD controller manual for programming procedures.
NOTE:
All keystrokes referred to in the following procedure are using the KBD-100A
Programming Keyboard.
1. Adjust the pan, tilt, zoom, and focus of the unit until the desired scene is displayed
on the monitor.
2. Press
SHIFT + F5
on the keyboard.
3. Type
the
PreShot Number
(0-97) and press
Enter
.
4. Type
the
title
of the PreShot (up to 24 characters) on the KBD-100A Keyboard
and press
Enter
. The following commands are displayed
C
to
Change
Change the location of the PreShot title on the display
E
to
Edit
Edit the PreShot title before saving PreShot coordinates
D
to
Delete
Delete PreShot
S
to
Save
Save PreShot coordinates and title
N
to
Save Name
Saves PreShot title only
