Rev. D
48
KDMU000799
02/6/04
6.6 PRESHOTS,
CONTINUED
If:
Then:
Still PreShot is ON
Video is frozen between PreShots. Video from the
old position remains until the scan arrives at the
new PreShot, then switches to the video from the
new PreShot. While video is frozen, an asterisk (*)
appears on the same line as the Camera ID.
PreShot
99
is reserved for manually controlling the NightShot mode on camera model
numbers 843216-1011 and 843216-1013. PreShot 99 toggles between standard
operation and the NightShot mode. The NightShot mode must be in the manual mode
for this PreShot to function. (Refer to
Section 5.5.3
to place the NightShot in manual
mode.) The NightShot mode causes the camera to pull the IR block filter and
automatically go to black and white to increase the sensitivity of the video.
6.6.1
List Programmed PreShots
A list of the programmed PreShots can be viewed for each scan unit by performing the
following procedure (for the Control Camera displayed on the programming controller).
The list displays the PreShot numbers and titles.
1. Press
F5
on the KBD-100A Keyboard.
2. Each
time
F5
is pressed, the next page of PreShots is displayed.
An “End of Directory” message appears at the bottom of the last page.
3. Press
ESC
when done viewing the PreShot list.
6.6.2
Go To PreShot Command
KBD-100A Keyboard
(secondary control camera, if selected; otherwise, primary control camera)
1. Press
F1
on the KBD-100A keyboard.
2. Type
the
PreShot number
(0-99) and press
Enter
.
JPD Series Controller
(secondary control camera, if selected; otherwise, primary control camera)
1. Enter
the
PreShot number
.
2. Press
PSHOT
.
NOTE:
If the 843216-1011 or 843216-1013 camera is installed, PreShot 99 is
reserved to toggle the scan in and out of the NightShot mode.
The NightShot mode must be in manual mode.
If the 843216-1010 or 843216-1012 camera is installed,
PreShot 99 can be programmed as desired.
