Rev. D
2
KDMU000799
02/6/04
1.2 EQUIPMENT
HANDLING
1.2.1 Domes
It is extremely important to treat the surface of all domes (smoked and clear) with the
same care as you would a fine camera lens.
•
Always handle the dome from its outside surface.
•
Refer to
Section 13 - Maintenance
for dome cleaning procedures
•
Only use non-abrasive cleaners for acrylic plastic on the clear and smoked
domes.
1.2.2 UltraDome
KD6i
Assembly
The UltraDome KD6i consists of:
•
the pan and tilt mechanism;
•
camera with zoom lens;
Available camera models are:
•
power supply board; and
•
digital receiver board.
Do not attempt to remove the camera from the scan assembly. If a camera or lens
requires service, the entire scan assembly must be sent back to the factory.
CAUTION:
The receiver board and power supply board
on the scan assembly have static sensitive devices.
The KD6i assembly is shipped in a pink bag that is static
dissipating. The unit should be handled in this bag until
installed. If the unit is shipped, it must be shipped in the
pink bag or an equivalent static dissipating enclosure.
1.2.3 Camera
Lens
•
Handle the camera lens with extreme care.
•
Never touch the lens surface.
•
Refer to
Section 13 - Maintenance
for information on cleaning the camera lens.
