Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
89
3. Route the cable from the Thor VM2 to the DC/DC power supply. Route the power
cable the shortest way possible. The cable is rated for a maximum temperature of
105°C (221°F). When routing this cable, it should be protected from physical
damage and from surfaces that might exceed this temperature. Do not expose the
cable to chemicals or oil that may cause the wiring insulation to deteriorate. Always
route the cable so that it does not interfere with safe operation and maintenance of
the vehicle.
4. Cut the cable to length and strip the wire ends.
5. Remove the lid from the DC/DC power supply.
6. Connect the stripped end of the positive wires (red and red/white twisted together or
a single red wire) to the output block. See
7. Connect the stripped end of the negative wires (black and black/white twisted
together or a single black wire) to the output. See
Note:
The input block has V
IN
+, V
IN
- and GND terminals.
The output block has V
O
+ and V
O
- terminals.
8. Connect the ground (green) wire from the Thor VM2 to the GND terminal on the
input side of the DC/DC power supply.
9. Route the wiring from the DC/DC power supply to the vehicle’s electrical system.
Do
not connect to vehicle power at this time.
10. Strip the wire ends and connect to the input side of the DC/DC power supply.
11. Use looms and wire ties to secure all wiring as shown.
12. Reattach the cover with the screws.
13. Connect the DC/DC power supply to the vehicle’s electrical system as directed
below:
•
V
IN
+ is connected to battery positive.
•
Vi
N
- must be connected to battery negative.
•
GND must be connected to the vehicle chassis ground.
•
V
IN
+ is connected to battery positive.
Caution: For battery powered vehicles:
Caution: For internal combustion engine powered vehicles:
Summary of Contents for Thor VM2
