Honeywell SmartDrive Compact, User Manual

Page: 40 / 75

Honeywell
Parameters 39
8
8.5 RAMPS AND BRAKES SETUP (CONTROL PANEL: MENU PAR -> P4)
8.6 DIGITAL INPUTS (CONTROL PANEL: MENU PAR -> P5)
Code Parameter Min Max Unit Default ID Note
P4.1 Ramp shape 0,0 10,0 s 0,0 500
0 = Linear
>0 = S-curve ramp time
P4.2 Acceleration time 0,1 3000 s 1,0 103
P4.3 Deceleration time 0,1 3000 s 1,0 104
P4.4
DC braking
current Unit
dep.
Unit
dep.
A Varies 507
P4.5
DC braking time at
start
0,00 600.00 s 0 516
0 = DC brake is off at
start
P4.6
Frequency to start
DC braking during
ramp stop
0,10 10,00 Hz 1,50 515
P4.7
DC braking time at
stop
0,00 600.00 s 0 508
0 = DC brake is off at
stop
P4.8 Flux brake 0 3 520
0 = Off 2 = Chopper
1 = On 3 = Full mode
P4.9 Flux braking current 0 7,4 A 519
P4.10 Ramp shape 2 0,0 10,0 s 0,0 501
0 = Linear
>0 = S-curve ramp time
P4.11 Acceleration time 2 0,1 3000 s 1,0 502
P4.12 Deceleration time 2 0,1 3000 s 1,0 503
Table 8.5: Motor control parameters
Code Parameter Min Max Unit Default ID Note
P5.1 Start signal 1 0 6 1 403
0 = Not used
1 = DI1
2 = DI2
3 = DI3
4 = DI4
5 = DI5
6 = DI6
P5.2 Start signal 2 0 6 2 404 As parameter 5.1
P5.3 Reverse 0 6 0 412 As parameter 5.1
P5.4 Ext. fault Close 0 6 0 405 As parameter 5.1
P5.5 Ext. fault Open 0 6 0 406 As parameter 5.1
P5.6 Fault reset 0 6 5 414 As parameter 5.1
P5.7 Run enable 0 6 0 407 As parameter 5.1
Table 8.6: Digital inputs