Honeywell Elster EK280, Applications Manual

Page: 52 / 223

EK280 Application Manual 50
6.5.1 Parameterizing by keyboard
i
The use of enSuite parameterizing software is strongly recommended for parameterizing a
status output (see below).
Parameterization with the keyboard on the EK280 is described below.
a) Setting up the output mode:
− Move the cursor to the tab " Serv. " and subsequently via the following path to the mode for the
corresponding output " Md.O1 " to " Md.O4 " :
Serv.

Outputs

Output 1

Md.O1
Serv.  Outputs  Output 2  Md.O2
Serv.

Outputs

Output 3

Md.O3
Serv.  Outputs  Output 4  Md.O4
i
The low-frequency event outputs of the EK280 can be operated with active or inactive
logic.(as a make contact or break contact). The output mode must be programmed accordingly
for this purpose (

below).
− Press the ENTER key. ⇒ The set value flashes.
− Press down one of the arrow keys

and/or

press repeatedly until the text „ Event(C) “
2
or
„ Event(O) “
3
flashes.
Whereby:
"(C)" = closer: When the message is activated, the output is switched on (closed).
"(O)" = opener: When the message is activated, the output is switched off (opened).
− Press the ENTER key to confirm the set value. It is possible to abort the entry by pressing the ESC
key.
b) Setting the status display for the output:
− In the corresponding output menu press the

key repeatedly until
" SpO1
",
" SpO2
",
" SpO3
", or
" SpO4 " is displayed.
− Press the ENTER key. ⇒ The set value flashes.
− Move the cursor with the arrow keys

or

to the digits and change these with the arrow keys

or

to a value that is specified in the table.
2
For software versions prior to V2.50, "Event+" (event +) is displayed.
3
For software versions prior to V2.50, "Event-” (event -) is displayed.