Honeywell ACS-8, Installation Instructions Manual

Page: 61 / 142

Installation Instructions / ACS-8 61
Table 2: Protocol and Baud rate
6 7 Function Connected to Comment
0 0 Setup via terminal program e. g. Event protocol (for
ethernet)
Switch positions 1-7
OFF
0 0 Ethernet interface card, encrypted
(Item no. 026840.30) Configuration
mode (Description see
documentation P55213-10-xxx) RS 232 (ST1, socket) Switch positions 1-5
ON
0 1 9-Bit-Protocol = factory setting
With these protocols,
the baud rate is
fixed
set at 19200.
1 0 DIN-66090-Protocol Interface converter
COMx / X-Port / X-Port Pro
1 1 RDT-Protocol Modem
ISDN card
0 = OFF
1 = ON
Table 3: Service-Function
8 Function
0
Factory setting (service function not active... switch positions 1 - 7 according to table 1 and 2)
1
Service function (switches 1 - 7 see table 4)
Warning! Switch 8 is reserved for service level functions and should not be changed
from the factory setting of OFF. Changing the switch setting may cause loss
of data.
Do not change factory settings!
Table 4: functions with the service switch activated
1 2 3 4 5 6 7 8 Function
1 1 1 1 1 1 1 1
Bootstrap
If the switch 8 ON state is detected, LED 1 on the CPU board flashes green until the next reset is carried
out.
The flashing green LED indicates that a function is in process. When this LED lights permanently, the
function has been completed
Procedure of bootstrapping:
1. Set all DIP switches to ON
2. Reset (reset push-button)
3. LED 1 flashes (wait)
4. LED 1 lights permanently
5. Switch DIP S1 to the required
position (baud-rate, address,
protocol, etc.)
6. Reset (reset push-button)